Progressive International Electronics Omega2 - Manual (Page 5)

O MEGA 2/O MEGA Lite Universal Site Interface Installation Guide
Version 1.0 October 2011
Page 1
System Installation
System Installation Warnings
Safety hazards are inherent with all electrical equipment. Standard precautions must be taken
at all times during installation and operation of the O
MEGA
units. In addition to normal
electrical precautions, the following points should be noted during installation.
C Installation must comply with National Electrical Code, as well as Federal,
State/Provincial, Local, and all applicable codes.
C High voltages are present in the O
MEGA
components, as well as the equipment to
which it is attaching. To prevent personal injury or equipment damage, disconnect all
power before proceeding with installation.
C O MEGA must be installed in nonvolatile, noncombustible, nonexplosive areas.
Typically, this is where the field wiring comes into the building. The box must be
protected from severe vibration, extreme temperatures and excessive humidity.
C All O MEGA and associated equipment must be installed in nonhazardous locations
and must be UL-listed, using standard communication.
For Use in USA
Installation of the O
MEGA
and associated equipment must comply with the requirements of
the National Electrical Code (NFPA 70), the Automotive and Marine Station Code (NFPA
30A), and all Federal, State, Local, and applicable safety codes.
For Use in Canada
Installation of the all fuel control equipment must comply with the requirements of the
Canadian Electrical Code, the Flammable and Combustible Liquid Code, and all Federal,
Provincial, State, Local, and applicable safety codes.
The installation of the systems covered by this manual in conjunction with equipment not UL Listed has not been evaluated by
the Underwriters Laboratories and is outside the intended use of this equipment. Warning: All dispensing equipment
discussed in this manual is not UL Listed and the combination has not been evaluated by Underwriters Laboratories.