Progressive International Electronics PIcon Console - Manual (Page 31)

PIcon Program & Report
Rev 2.0 June 2006 Page 27
Initiate programming of Print Header by pressing <9> and then <ENTER>. The display
shows the beginning information for the printer header. If your header has not been
programmed or has been cleared, the cursor will prompt you for your first character entry.
(Refer to Table: Print Header Character Codes, at the end of Mode 11 description, for
a numeric code which represents the characters available for your use on the printer
header.) Determine the character you wish to place in the first position of the header and
look up the numeric code. Enter this numeric code on the keypad and press <ENTER>.
The character will appear on the display, and has been saved in memory. For each
subsequent character, follow the sequence described above.
There are two special numeric codes for the header: <10> indicates a new line in the
header; <01> is the code for end of header. Enter the new line code at the point where
the printer should cease printing on the current line and go to the beginning of the next
line. The end of header code is entered after the entire header is entered and will tell the
PIcon that no more characters are needed in the header.
Special editing features are available for use under Print Header:
<ENTER> without entering a numeric code — The display cursor will increment to
the next character in the header.
<SELECT> without entering a numeric code — The display cursor will go back one
character in the header.
<CHNG> without entering a numeric code — The entire printer header will be
cleared.
<PRINT> without entering a numeric code — The printer will print the header that is
programmed.
<MNGR> — Exit Print Header programming.
Press <MNGR> to exit Mode 11.