Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 3)

3
F Key Switch Turning the key turns ON/OFF the GP unit power supply.
G CF Card Cover
The CF Card I/F, USB I/F, DIP Switches and LAN status LED are
located in the CF Card Cover open.
• During operation of the GP unit, keep the CF Card cover
closed. If the GP unit is used with this cover open, it will
cause a fault of the GP unit.
H USB Host Interface
Complies with USB 1.1. Uses a “TYPE-A” connector. Power
supply voltage: DC5 V±5%,
Output current: 500 mA (max).
Connect to the transfer cable, storage device (USB memory, CF
Card reader), etc.
The maximum communication distance: 5 m.
I CF Card Interface Insert the CF Card in this slot.
J Dip Switches
• After inserting a CF Card, be sure to turn ON DIP Switch 4, and
close the CF Card cover before using the GP unit.
• Before removing the CF Card, turn OFF DIP Switch 4 first, and
make sure that the CF Card access LED turns off. If you remove
the CF Card while the CF Card is being accessed (while the
LED is lit), it may result in data corruption.
1 2 3 4
ON
Dip
Switches
Function ON OFF Note
1
CF Card Startup
Settings (Controls
unit startup from
the CF Card.) Startup
from CF
Card is
enabled. Startup
from CF
Card is
disabled. CF Card
with startup
data
required.
2
*1
*1 When power supply is turned ON at DIP Switch 2 is ON, it starts with
Transfer Mode. Usually, use it in OFF.
Forced Transfer
Mode
Forced
Transfer
Mode: ON Forced
Transfer
Mode: OFF
⎯
3 Booking
⎯ ⎯
Constantly
OFF
4
CF Card access
setting
CF Card
access
enabled CF Card
access
disabled
⎯