Proface FP3900 - 19 Flat Panel" - Manual (Page 3)

3
8) Connect the backlight's two (2) power
connectors. Next, close the circuit board
and secure the rear case in place using
the attachement screws removed in steps
1), 2) and 3).
5) Disconnect the backlight's two (2) power
connectors.
6) Loosen the backlight unit attachment
screw (the screw cannot be separated
from the backlight unit), slide the back-
light in the direction shown and remove
it from the GP/PS.
7) Insert the new backlight in the GP/PS.
Insert the unit by sliding it in the direc-
tion shown in step 6), then, tighten the
unit’s attachment screw.
Upper Section
Lower Section
Attachment Screw
Power Connectors