Watlow CPC400 User Manual
Cpc400 series user’s guide
Advertising
CPC400 Series
User’s Guide
Watlow Controls
1241 Bundy Blvd.
Winona, MN 55987
Repairs and Returns:
334 Westridge Drive
Watsonville, CA 95076
Customer Service:
Phone.....1-800-414-4299
Fax .........1-800-445-8992
Technical Support:
Phone.....(507) 494-5656
Fax .........(507) 452-4507
Email [email protected]
Part No. 0600-2900-2000 Rev. 2.2
August 2005
Advertising
Table of contents
Document Outline
- Title
- Table of Contents
- List of Figures
- List of Tables
- System Overview
- Installation
- Operation and Setup
- General Navigation Map
- Keypad
- Displays
- Changing the Set Point
- Changing the Control Mode and Output Power
- Accessing and Navigating the Setup Menus
- Setting Up Closed-Loop Control
- Setting Up a Process or Pulse Input
- Autotuning
- Setting Up Alarms
- Setting Up Process Variable Retransmit
- Setting Up Cascade Control
- Setting Up Ratio Control
- Setting Up Differential Control
- Setting Up Remote Analog Set Point
- Setting Parameters Through Serial Communications or a LogicPro Program
- Tuning and Control
- Menu and Parameter Reference
- Operator Parameters
- Overview of the Setup Menus
- Global Setup Menu
- Load Setup From Job
- Save Setup as Job
- BCD Job Load
- BCD Job Load Logic
- Mode Override
- Mode Override Digital Input Active
- Logic Program
- Power Up Alarm Delay
- Power Up Loop Mode
- Power Up With Logic
- Keypad Lock
- Thermocouple Short Alarm
- Controller Address
- Communications Baud Rate
- Communications Parity
- AC Line Frequency
- Digital Output Alarm Polarity
- Model and Firmware Version
- Input Menu
- Channel Menu
- Control Menu
- Output Menu
- Alarms Menu
- Process Variable Retransmit Menu
- Cascade Menu
- Ratio Menu
- Soft Integers Menu
- Soft Booleans Menu
- I/O Tests Menu
- Additional Parameters for Serial Communications and LogicPro Programs
- Troubleshooting and Reconfiguring
- When There is a Problem
- Troubleshooting the Controller
- Corrective and Diagnostic Procedures
- Additional Troubleshooting for Computer Supervised Systems
- Clearing the RAM
- Replacing the Flash Memory Chip
- Changing the Hardware Communications Protocol
- Installing Scaling Resistors
- Configuring Serial DAC Outputs
- Configuring Dual DAC Outputs
- Specifications
- Appendix A: Modbus Protocol
- Glossary
- Index
- Parameter Address Reference
- Declaration of Conformity
- Menu Structure