Asus A7N266-VM - Manual (Page 43)

ASUS A7N266-VM motherboard user guide 31
18) USB Headers (10-1 pin USB23, USB45)
If the USB port connectors on the back panel are inadequate, two USB
headers are available for four additional USB port connectors. Connect a 2-
port USB connector set to a USB header and mount the USB bracket to an
open slot in the chassis. (The USB connector set is optional and does not
come with the motherboard package.)
A7N266-VM
®
A7N266-VM Front Panel USB Headers
USB23 USB45
USB Power USBP2
–
USBP2+ GND NC
USB Power
USBP3
–
USBP3+
GND
1 5
6 10
USB Power USBP4
–
USBP4+ GND NC
USB Power
USBP5
–
USBP5+
GND
1 5
6 10
A7N266-VM
®
Front View Back View
+5V IRTX
IRRX
(NC) GND
+5V IRRX IR
TX
GND
IR
1
A7N266-VM Infrared Module Connector
19) Infrared module connector (5-1 pin IR)
This connector supports an optional wireless transmitting and receiving
infrared module. This module mounts to a small opening on system chassis
that support this feature. You must also configure the UART2 Use As
parameter in BIOS to set UART2 for use with IR. See section “4.4.2 I/O
Device Configuration” for details.
Use the five pins as shown in Back View and connect a ribbon cable from the
module to the motherboard SIR connector according to the pin definitions.