Watlow Series 922 Retrofit - Manual (Page 28)

20
WATLOW Series 922 User's Manual Sample Program, Chapter 3
Sample Program
F ILE ?
START
RESUME?
( )
( )
[ ] SP1
EV1
EV2
[ ]
[ ]
[ ]
F ILE
STEP
SETPOINT
SE1
HOUR
MIN
SEC
JUMPLOOP WAITFOR
[ ]
[ ]
[ ]
[ ]
W1
W2
WHR
[ ]
[ ]
[ ]
AUTOSTART
DAY
HOUR
MIN
STOP LINK
F ILE [ ]
[ ]
[ ]
[ ]
00 : 00 : 00 00 : 00 : 00
00 : 00 : 00
One of the three step types will be displayed
depending on the type of step PROGRAMmed.
JUMPLOOP, STOP, and LINK step types are immediate, and will not be visible.
To SYSTEM Menu
SP2
C2/RH
EV3
EV4
EV5
EV6
EV7
EV8
SE2
WMN
WE
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
EI
RETURN
[ ]
[ ]
Running Your Series 922
To run your Series 922, you must be at one of the three main level operating
parameter menus, SYSTEM, PROGRAM, or SETUP. Press the RUN/HOLD key.
The Series 922 asks what file you want to run, and asks what step to begin with.
After entering the file and step number, your program begins, and the RUN LED is
lit. While in the RUN mode, you can only view the current file and step.
To stop a running program, press the RUN/HOLD key. To resume a previously
halted program press the RUN/HOLD key. When the FILE? parameter appears,
press the MODE key to advance to the next parameter. When START appears,
press the MODE key again. Next, the RESUME? parameter is now present. Press
ENTER.
Where To Go From Here
Good job! You've just programmed and run the Series 922 sample program.
As soon as you feel comfortable with the Series 922 sample program, move on
to Installation and Wiring, Chapter 4. Or if you have already installed and wired
your system, go to the Master Step Chart in Chapter 5 and begin entering and
documenting your Series 922 program.
RUN Menu
AT THE SYSTEM prompt, press to continue to PROGRAM mode.
Press to enter the PROGRAM parameter values, or
press to continue to SETUP. M
E
M
= MODE Key
= ENTER Key
= UP/DOWN Key
M
E
NOTE: Shaded
parameters may
not appear on
your control.
These parameters
are dependent on
how your control
is configured.
See Chapter 6 for
more information.
Figure 8 -
RUN Key Flow
Diagram
SYSTEM