Asante Technologies SECURE NET 6001/P/W - Manual (Page 2)

Wireless networking
POWER
Alarm
Infrared inductor
Alarm
HUB
Video in
DVR
Digital Video
Recorder AMP
MIC
AMP
WAN Internet
PTZ Surveillance
RS485
Alarm input
Alarm output
2.
Connect Video cable.
1.
Connect your analog camera using
RS-485 to this product.
6.
Connect the switch hub to your PC
(as shown in the figure) .
5.
Connect the product to the
switch hub (as shown in the figure) .
4.
Connect the product to the
power source.
Link
Connect RS-485 Cable
4.
5.
6.
Step
Connect the product to the switch/hub and analog camera
Connect the video server using LAN.
3.
Connect your camera
to the power source
(as shown in the figure)
Connection diagram
If No Switch/Hub
You may connect Ethernet direct
from PC to product. However,
you will need to confirm your IP
address to the existing network.
You may also need a crossover
cable. It is highly recommended
that you have an IT professional
assist you.
Search for the product from your LAN. The factory
IP setting 192.168.0.20 appears on the screen.
Run the IP Finder.exe file from the CD.
1
4
Submit the change
Open the IE browser
Tools
Internet Options
Security
Custom Level
Note: This product supports IE 6.0 or above.
Step
Step
IP Address settings
Start
When you find the camera, click it and the settings
appear on the right side. Change the settings for the
new network environment you need.
Change the Internet Explorer settings
2 Search the product on the network
.
3
Changing the IP address, Netmask,
Default Gateway
4
Click Submit to validate new settings.
4
Confirmation 5
You may “search” again to confirm the change is
correct. After that, you can “exit”.
Bring Up Your IE browser
Start
Make sure that Level II, the commonly used default
security level, is set for the security.
2 Check
Steps
4 OK
Click OK to quit.
1 3 Select “medium” for security