Wright Serial #62995 and higher - Manual (Page 20)

18
4.6 Digital Hour Meter
The ZTO is equipped with a digital hour meter. Refer to operating/reset instructions below.
The programming specified is:
Default display: Hours
Press once (TMR1): Timer 1, press for 3 sec to reset
Press twice (TMR2): Timer 2, press for 3 sec to reset
Press three times (svc ENG): Will display time remaining until next service
point, hold down to reset. The first interval is 8hr, thereafter 100hr.
Beginning 5hr before service point the meter will flash “svc ENG, in
[remaining hours]” every 5 sec.
Shut off engine: Will display how many times the engine has started.
4.7 Deck Lift Lever
The foot operated deck lift is used to raise and lower the deck. Deck is to be in the up position when in
transport, go over curbs, loading and unloading on to a truck or trailer. The ZTO has a deck lift assist spring
but optional Deck Lift Foot Lever Extension Kits are available thru all Wright Dealers. (P/N 95460011)
4.8 ROP’s
A Roll Over Protection System (ROP’s, P/N 98410135) and seat belt is provided with the Wright ZTO. Do not
remove the ROP’s and the seat belt.
•
Inspect ROP’s and seat hardware after the first 100 hrs of
operation and every 6 months for loose or missing hardware.
•
Inspect the seat latch to make sure it is functioning properly.
•
Make sure Retaining ring and clevis pin are fully installed and
lanyard is in good condition.
•
Keep ROP’s fully extended.
•
Use seat belt
Deck
Lift
Lever
Retaining
Ring
Pull Pin
w/
spring