Wright Serial #62995 and higher - Manual (Page 22)

20
5.2 How to start the mower
Before starting the engine
• Make sure the control levers are in the Parked/Brake, outward position
• Turn OFF the blade engaging switch if it is on.
• Turn fuel valve to the “On” position.
Note: The fuel valve is located on the left side, rear of the seat frame.
Starting the engine
•Start the engine according to the engine manufacturer’s recommendation, see engine manual. Set the throttle
control lever near mid throttle. Set the choke lever to full choke. Turn the key to the start position. Do not
engage the starter for more than five (5) seconds at a time. This may overheat the starter and the wiring
systems. Wait ten (10) seconds between attempts. If the engine does not start after several attempts or
stalls frequently, take the mower in for service.
After starting the engine according to the engine manufacturer’s recommendation, pull back on the choke
control knob to open the choke valve, let the engine run for 3-5 minutes at mid throttle to allow sufficient warm
up. Do not over-rev a cold engine.
Unusual noises or irregular operation:
As you drive the mower, listen for any unusual noises and test for irregular operation and adjust or service as
necessary.
5.3 How to drive the mower
While sitting, both feet should be firmly placed on the foot platform. Set the engine speed about a fourth of the
way from idle. Release the parking brake by moving the control handles to the “In” position. Now try moving
the hand control levers, one at a time, very slightly, forward and backward. Check to see if the wheels move
forward and backward according to the position of the levers
. With both feet still firmly placed on the foot
platform, increase the engine speed to about half of the way from idle speed. The higher engine speed will
make the controls much more responsive and the mower much quicker; Use caution if it is your first time. Now
try moving the hand control levers, one at a time, very slightly, forward and backward. Gradually increase your
speed until you are well acquainted with the operation of the hand controls and the mower’s behavior. After
gaining a good feel for how the mower handles, gradually attempt higher engine speeds until familiar with
operation at full throttle engine speed.
5.4 How to Stop and Park the Mower
Come to a complete stop. If the blades are on, turn them off using the blade switch on the instrument panel.
Make sure the control levers are in the outward position, parked/brake on. Reduce the engine speed to idle
and let run for 3-5 minutes, shut off the ignition switch to stop the engine and then remove the key from the
ignition switch. The mower is now parked. Do not leave mower unattended on a sloped surface.
Parked / Brake On
WARNING