Start the washing program – AEG KO-LAVAMAT 88830 User Manual

Page 24

Advertising
background image

Instructions for use

24

Start the washing program

0

1. Check that the water valve is open.

2. Start the washing program:

Press button START/PAUSE (MARCHE/PAUSE).
The washing program is started or it starts after
the set time expires.

3

If DOOR/LIGHT (PORTE/LUMIERE) flashes red when the button START/
PAUSE (MARCHE/PAUSE) is pressed the filling door is not closed prop-
erly. Press the filling door shut firmly and press button START/PAUSE
(MARCHE/PAUSE) again.

If the delay timer is set:
The preset delay timer is counting, the remaining time until the
program starts is shown in the multi-display (always in whole hours).
During this time you can load washing or change / abort the time
preselection.

• Load washing: Press the START/PAUSE (MARCHE/PAUSE) button, the

filling door can be opened. Then close the door and press button
START/PAUSE (MARCHE/PAUSE) again.

• Change or abort time preselection: Press the DELAY TIMER (DEPART

DIFFERE) button as often as is necessary until the required time is
displayed; when the program run time is displayed (display in
minutes, e.g. 125) the washing program starts without delay.

3

While the time preselection counts the washing machine switches to
the stand-by mode. Only RUN TIME (TEMPS RESTANT) is illuminated,
the multi-display shows the remaining time until the program start.
All other displays on the control panel are switched off in order to save
energy. Pressing any arbitrary button cancels the stand-by mode.

Advertising