ATEN CE-220L - Manual (Page 9)

- 7 -
Installation
Setting up the CE-220 KVM Extender system is simply a matter
of plugging in the cables. Refer to the installation diagram on the
following page and do the following:
1. Make sure that all the equipment to be connected up is
powered Off.
2. Plug the cables from the local console devices (mouse,
keyboard, monitor), into their ports on the Console side of the
Local Unit (CE-220L).
3. Plug the appropriate connectors on the KVM cable supplied
with this unit into the CPU side of the CE-220L. Each
connector is marked with an appropriate icon to indicate
which it is.
Note: The female monitor connector is the one that plugs into
the CE-220L.
4. Plug the connectors on the other end of the cable into the
appropriate ports on the computer (or Console section of the
KVM switch if you are using one). Each connector is marked
with an appropriate icon to indicate which it is.
5. Plug either end of the Category 5 twisted pair cable into the
CE-220L's Remote I/O port.
6. Slide the Range Switch to the Long position if the Remote
Unit’s location is more than 30m away; slide it to the Short
position if the Remote Unit’s location is less than 30m away.
7. Plug one of the power adapters (supplied with this package)
into an AC source; plug the adapter's power cable into the
CE-220L's Power Jack
8. Plug the other end of the Category 5 twisted pair cable into
the I/O port of the Remote Unit (CE-220R).
9. Plug the cables from the remote console devices (mouse,
keyboard, monitor), into their ports on the Console side of the
CE-220R.
CE220.fm Page 7 Wednesday, November 22, 2006 10:55 AM