AMX Video Sync Sensor VSS2 - Manual (Page 11)

Installing The VSS2
5 VSS2 Video Sync Sensor
Installing The VSS2
You can install the VSS2 on any flat surface that has unobstructed access to the rear panel
connectors. The following describes how to set up and install the VSS2.
Connecting the Wiring
You can connect up to two video devices to the RCA plug-in connectors on the VSS2. Once
attached, you can connect up to two external sensing devices, a television manager, or a AMX
control system to the four-pin Sense out connector on the rear panel. The following describes how
to connect your video devices, external equipment, and the 12 VDC power supply
Video 1 and 2 connectors
FIG. 4 shows how to connect your video devices to the Video 1 and 2 RCA plug-in connectors on
the rear panel.
Sense out connector
FIG. 5 shows how to connect two external video-sensing devices.
FIG. 4 Video RCA connector diagram
FIG. 5 External video sensing wiring diagram
Video
Source 1
OUT
VSS2
IN
Video
Source 2
Video
Destination
1
Video
Destination
2
OUT IN
OUT IN
OUT IN
Video
1
Video
2
GND2 Sense out
connector
Sense 2 SENSE2
GND1
SENSE1
Sense 1