MAHLE RTI MCX-2 (Rev A) - Manual (Page 9)

Page 8
Water
Pump
Connecting at Engine
SYS TEM
OFF
ON
SYS TEM VA CU UM
ON
EM PTY W AST E
FILL
OFF
ON
TES T FIL L
SYS TEM PR ESS UR E
OFF
SYS TEM DR AIN
Hose
Radiator
Step
Adapters
Radiator
Overflow
Green Hose
Black Hose
Block
Engine
Connecting at Radiator
Black Hose
SYS TEM
O FF
ON
SY STE M V ACU UM
ON
EM PTY WA STE
FILL
OFF
O N
TES T FIL L
SYS TEM PR ESS URE
O FF
SYS TEM DR AIN
Step
Adapters
Adapter
Hose
Radiator
Hose
Radiator
Overflow
Water
Pump
Green Hose
Engine
Block Heater
Core
Adapter
Hose
Heater
Core
CONNECTING TO THE COOLANT SYSTEM
The MCX-2 can be connected to the cooling system in either of the configurations
shown below. The choice is dependent on the ease of accessability to the hose
connections.
1. Disconnect the radiator hose from either the engine or the radiator.
2. Select an Adapter Hose with the same inner diameter as the radiator hose and
connect at the point the radiator hose was disconnected using a clamp.
3. Install Step Adapters in the Adapter Hose and the radiator hose using clamps.
Make sure the outside diameter of the Step Adapters is the same as the inner
diameter of the radiator hose.
4. Connect the Green and Black hoses from the MCX-2 to the two Step Adapters
as shown in the illustrations. BE CAREFUL - GET THEM RIGHT !!!!
5. Open the valves on the two Step Adapters.