MAHLE RTI TechAlert - Manual (Page 13)

12
Remote Deep Sleep Mode
This mode is useful when the Remote Module will be “out of range” for
extended periods of time. In sleep mode, the remote will not respond to
any signals from any synchronized Base Module.
To enter sleep mode, press and hold the Remote Push Button for (5)
consecutive flashes of all (4) LED’s and then release the push button.
After (5) consecutive flashes of a (4) LED’s, the remote is in deep sleep
mode.
To wake up the Remote Module, press and hold the Remote Push
Button for (3) seconds and then release. All (4) LED’s will flash and
there will be (1) audible beep and a (1) second buzz. All previous
synchronizations will be maintained.
NOTE: To maximize remote battery life, place remote into sleep mode
when unit monitoring is not required.
Automatic Deep Sleep Mode
This function is used when you want the remote to automatically switch
itself to deep sleep to conserve battery life, or to ignore any signals
received when away from the unit. The automatic deep sleep mode can
either be disabled or enabled. The remote is sent from the factory as
deep sleep mode disabled. If enabled after approximately 2 hours
without receiving an alert, the remote will automatically enter deep sleep.
To wake up the Remote Module, press and hold the Remote Push
Button for (3) seconds and then release. All (4) LED’s will flash and
there will be (1) audible beep and a (1) second vibration. All previous
synchronizations will be maintained.
To enter Deep Sleep Mode Programming, press and hold the Remote
Push Button for (2) consecutive flashes of all 4 LED’s and then release
the push button. The lit LED will indicate the current programmed deep
sleep setting; #1 LED indicates the Automatic Deep Sleep is disabled, #2
LED indicates the Automatic Deep Sleep is enabled. To change the
status, press and release the Remote Push Button to toggle to the
desired LED. Allow 20 seconds for the remote programming to time out
to continue normal operations.
Total Remote Reset
This function is used when you want to reset the remote to remove any
synchronization that is associated with it. To reset the remote, remove
the screw on the rear of the Remote Module to access the battery
compartment. Remove the batteries. While pressing the Remote Push
Button, re-install the batteries.