Nexo GEO D - Manual (Page 32)

Page 32/97 GEO D RIGGING PROCEDURE
5.4 GEO D Cluster Flying Setup (1 motor)
Flying a GEO D10 cluster from 1 motor requires the following accessories:
• 1 x Motor properly rated
• 1
x Geo-Bridle (GEO-BRIDLE)
• 1 x GEO D Main Bumper (GEOD-BUMPER)
• 1 x GEO D Short Extension Bar (GEOD-EXBAR1)
• 1 x GEOD Front Extension Bar if strong positive tilt is required (GEOD-EXBAR4)
• 1 x GEO D Compression Wheel (GEOD-ORP)
• 1 x GEO D Bottom Bumper (GEOD-BTBUMPER)
• 1 x GEO D Chain Lever Hoist (LEVA0750 or LEVA1500)
• 1 x Chain Bag (CHBAG)
• 6 x GEOD push-pins per flown GEO D10 (BLGEOD)
• or 1 x GEOD shoulder bolts and nuts kit for fixed installations per flown GEO D (GEOD-BNFIX)
IMPORTANT
Motor and chain lever hoist must be rated to support the entire cluster weight.
Please check configurations in Geosoft2 for proper motor and chain lever hoists rating.
5.4.1 Allowed “One Rigging Point” Configurations
IMPORTANT
- “One rigging point” mode is strictly limited to GeoD clusters (no Geo Sub allowed);
- Maximum GeoD quantity allowed for this mode is 8;
- Compression Wheel and Bridle are designed for Extension Bar EXBAR1 and must not be
used with Extension Bar EXBAR2.
5.4.2 Bumper Assembly
• Strong bumper positive tilt only; connect the Front Extension Bar Bumper through the Link
Points the with the two axes using corresponding holes (see drawing below), and ensure that
these axes are properly locked with supplied “R” clips;
Link Points
LINKING GEOD BUMPER AND EXTENSION BAR EXBAR4