Nexo GEO D User Manual

Page 54

Advertising
background image

Page 54/97

GEO

D

RIGGING PROCEDURE

IMPORTANT

Ensure angle settings are identical on both sides of the cabinet.

5.6.5 First to second GEO D 10

4 push-pins (BLGEOD, 10mm diameter x 20 mm length) connect first to second GEO D10, 2 additional
push pins-are required for angle adjustment.

• Lift cluster, and position the next GEO D10 below the assembly, with NEXO logo on the same

side than the upper cabinet.

• Lower cluster carefully until the first and second GEO D10 side rigging plates locate. Use front

grid, rear vent ports or handle to guide the assembly. The rigging plates have been designed to
locate against each other and so align the holes correctly.

• Connect the upper GEO D link bar to the lower GEO D rigging plate (or lower link bar to upper

rigging plate for “Right” configuration) by inserting one 10mm x 20 mm push-pin in the “SAFETY
PIN MUST BE FITTED” hole on each side (see figure below).

IMPORTANT

The push-pins for “SAFETY PIN MUST BE FITTED” holes must always be inserted first and
stay in position permanently. NEVER REMOVE THEM ONCE CABINETS ARE SUSPENDED.

• Insert two additional 10mm x 20mm push-pins in the front holes (see figure above).
• Lift the cluster to a height that allows convenient access to the linking bars and the angle setting

holes.

• Insert 1 additonal push-pin to the required angle value hole on each side
• Check that all 6 push-pins are locked.

« SAFETY PIN MUST BE FITTED »

HOLE

Advertising