Stewart Audio CVA50-1 Priority PA - Manual (Page 8)

14
2.5.1 Constant Voltage
The Euro Block connector on the rear of the amplifier is capable of sup-
plying output at 70V.
2.5.2 Wiring Example
The diagram below is a typical wiring setup for two speakers with out-
board step-down transformers wired in parallel to the 70V output op-
tion of a CVA50-1 Priority PA amplifier.
15
3 Operation
3.1 Operating Precautions
1. Before use, your amplifier must be configured for proper opera-
tion, including input and output wiring hookup. Improper wiring
can result in damage to equipment or potentially harm to the
operator. Consult section 2 for setup instructions.
2. Tampering with the circuitry, or making unauthorized changes
is not only dangerous but may also violate local regulations.
3. Use care when making connections between the amplifier and
the input or output equipment. Using equipment that is not
capable of handling the output wattage may lead to permanent
damage.
NOTE: Stewart Audio will not be held responsible for
damage to your CVA50-1 Priority PA amplifier or connect-
ed equipment if the instructions in this manual are not
followed.
NOTE: For additional operating precautions, please refer
to “Important Safety Instructions” located on Page 2.