STI 7523 User Manual

Installation of sti-7523 enclosure, Installation of alarm assembly, 1/4” diameter

Advertising
background image

MAGNET

6297520 GASKET
(1) PROVIDED

04874
MOUNTING
PLATE

SCREW #8-32 x 1/2 in.

(4) PROVIDED

AMS-10S MAGNETIC CONTACT

SWITCH WITH 24 in. WIRE LEADS

19013 SCREW

#10 x 1 1/2 in.

(4) PROVIDED

06298 MOUNTING TABS

(4) PROVIDED

19033 ANCHOR

(4) PROVIDED

STI-7523 THUMB LOCK
STI-7522 KEY LOCK AVAILABLE

ST

OP

STOP

EM

ER

GE

NC

Y U

SE

ON

LY

INSTALLATION OF STI-7522 & STI-7523 PROTECTIVE CABINET

Safety Technology International, Inc. • 2306 Airport Rd. • Waterford, Michigan 48327-1209 • 800-888-4784 • Fax: 248-673-1246 • Web: www.sti-usa.com • Email: [email protected]

ALARM MOUNTING PLATE

CABINET

WIRE ACCESS HOLE

ROUTE THE 2 SWITCH WIRES
THROUGH THE HOLE AS SHOWN

VIEW A

OPTIONAL MOUNTING
HOLES (4)

A

9 VOLT ALKALINE BATTERY

ALARM COVER

19016 TAMPERPROOF TOOL

19032 KEY (2) PROVIDED

19011 SCREW - TAMPERPROOF

(2) PROVIDED

19039 SCREW

#6 x 1 1/4 in.

(2) PROVIDED

ALARM MOUNTING PLATE

06202 BACKPLATE

ST

OP

EM

ERG

ENC

Y U

SE

ON

LY

STOP

19018 ANCHOR (2) PROVIDED

T

INSTALLATION OF STI-7523 ENCLOSURE

1. Insert the (4) mounting tabs fully into backbox mounting tab

slots. Use rubber mallet if necessary.

2. After selecting a suitable location, place enclosure in closed

position, against the wall. Mark and drill (4) 1/4 in. diameter
holes. Insert the (4) 19033 anchors. Close and lock enclosure.

3. Place enclosure in position making sure the (2) switch wires

are not pinched between the wall and enclosure. Drive in the
(4) screws. Enclosure is now secure.

1. Place the alarm mounting plate on the

top center of enclosure. Select at least
two of the four optional mounting
holes. Mark and drill 3/16 in. holes and
install the 19018 anchors.

2. Fish the magnetic switch wires through

the alarm mounting plate and the siren
backplate (View A). Next, drive the two
alarm mounting screws into the
previous installed anchors.

3. Install the two magnetic switch wires

following the terminal switch diagram
(View B).

4. Install the alarm cover using the (2)

tamperproof screws and provided tool.

*

1/4” Diameter

INSTALLATION OF ALARM ASSEMBLY

3.125 in.(79mm)

10.875 in.

(276mm)

8.875 in.(225mm)

STOP

EMERGENCY USE ONLY

P

FRONT VIEW

TOP VIEW

16.00 in.

(406mm)

M

*

Advertising
This manual is related to the following products: