Dip switch settings, Programmable features – STI AP-1-G-I User Manual
Page 3
- 3 -
Integral Sounder Tones (DIP Switch No. SW1-SW3)
The Alert Point Lite has seven different selectable alarm tones ranging from 95 to 102dB.
Sounder Timer Options (DIP Switch No. SW5 & SW6)
Four alarm conditions are available and can be selected by changing the DIP switch settings. These are:
30 seconds, 3 minutes, 20 minutes or continuous.
If any duration other than “continuous” is used, the alarm will silence after the selected time has elapsed.
This alarm will NOT be able to be reactivated until the unit is reset with the reset key.
Key Switch – Reset (DIP Switch No. SW7)
This allows the user greater control if misuse becomes a major factor.
SW7 position - ON: The Alert Point Lite will fully reset after activation when using the reset key.
SW7 position - OFF: Even if the Alert Point Lite is reset after activation using the reset key, all sounders
will continue to run until the unit is reset using the master key switch.
DIP Switch Settings
Important: Changes to any DIP Switch settings will only take effect after the Alert Point Lite has been
reset using the master key switch (turn “OFF” then back “ON”).
FEATURES
DIP SWITCH SETTING
ACTION
Integral
Sounder Alarm
Tone
SW1
SW2
SW3
Tone
Sound Pattern
OFF
OFF
OFF
1
800Hz - 970Hz (Sweep)
ON
OFF
OFF
2
800Hz - 970Hz (Sweep)
OFF
ON
OFF
3
988Hz / 250ms - 645Hz / 250ms (Alternating)
ON
ON
OFF
4
670Hz / 250ms - 845Hz / 370ms (Alternating)
OFF
OFF
ON
5
800Hz - 970Hz in 350ms (Sweep)
ON
OFF
ON
6
2400Hz - 2850Hz in 110ms (Sweep)
OFF
ON
ON
7
2400Hz - 2850Hz in 330ms (Sweep)
ON
ON
ON
8
Not implemented
SW5
SW6
Sounder Duration
OFF
OFF
Sounders run continuously (until manually reset)
ON
OFF
Sounders switch off automatically after 30 seconds
OFF
ON
Sounders switch off automatically after 3 minutes
ON
ON
Sounders switch off automatically after 20 minutes
Alert Point Lite returns to “standby” condition after resetting
with reset key.
Alert Point Lite latches in “alarm” condition until it is
manually reset using the master key switch.
The Alert Point Lite expects to be connected to another Alert
Point Lite, otherwise a warning beep is emitted.
No fault will be indicated if an Alert Point Lite is not connected
to another Alerrt Point Lite, it is not looking for a connection.
SW4 ON
Not used
SW4 OFF
Not used
Sounder
Duration Timer
Reset
Networking
the Alert Point
Lite
Factory setting
SW7 ON
SW7 OFF
SW8 ON
SW8 OFF
Programmable Features