STI AP-1-G-I - Manual (Page 7)

- 7 -
Specifications
Power source
9V DC battery (included)
Standby current 45µA
Alarm current 28mA (low volume) / 32mA (high volume)
Operating temperature 32° to 120°F (0° to 49°C)
Sounder output (at 1m) 95 – 102dB
Sounder tones 7
Network >2 units spaced less than 50m apart
Fault Finding
A simple test completed on each individual unit will immediately highlight if any of the following faults are
evident:
Low Battery condition, Network connection loss
Using the master key, turn the unit “OFF” and then back “ON.”
• If no audible beeps sound within 5 seconds, the unit has no faults.
• If a short single beep sounds within 5 seconds the unit has a low battery fault.
Replace the battery.
• If 2 short beeps sound within 5 seconds the unit has a network fault. Check all the network cable
terminations and/or the wiring associated with the input signal to the device.
Warranty
Safety Technology International, Inc. warrants to the original consumer/purchaser what this product shall
be free of defects in material and workmanship under normal use and circumstances for a period of one
(1) year from the original date of purchase.
Electronic warranty form at www.sti-usa.com/wc14.
NETW
ORK IN
NETW
ORK
CO
MMON
NETW
ORK OUT
EXTERNAL SOUNDER
EXTERNAL SOUNDER +
-
Note:
All external sounders
must be hard-wired
using 2-core cable, and
must have their own
power supply.
It is recommended
that external wiring
does not exceed 50
metres.
VOLUME JUMPER CONNECTION (3 PINS)
DIP SWITCHES
PCB Terminal Diagram