STI V34750 - Manual (Page 4)

- 4 -
PROGRAMMING
1. Plug in receiver.
2. Listen to verbal voice commands. They will guide you through programming.
Notes
· Firmly press acknowledge button at any time to stop voice.
· Make sure battery is installed in sensor.
· Each sensor provides an initial sound (DONG).
(See CHART 2 below)
· Each zone button, with programmed sensor, scrolls through default messages using
the zone/message selection button.
· Accept tone/message selected by moving switch to NORMAL mode. These can
be changed at any time by moving the switch to PROGRAM and pushing the
zone/message selection button.
SCROLLING MESSAGE/TONES - Default messages by sensor type
Universal Doorbell Driveway Pool/Entrance Indoor and
Garage Sentry Button Monitor Alert Outdoor
Mailbox Alert PIR
Mailbox Call Front Driveway Pool Door Motion Front
Door Alert Side Driveway Pool Gate Motion Side
Gate Assistance Rear Driveway No Sound* Motion Rear
Window Service No Sound* Ding Motion Driveway
Cover Door Ding Ding Dong Motion Upstairs
Garage Sentry Customer Ding Dong Dong Motion Downstairs
Temperature No Sound* Dong 4-Note Chime Customer
Sump Pump Ding 4-Note Chime 8-Note Chime No Sound*
Freezer Ding Dong 8-Note Chime Knock Ding
Refrigerator Dong Knock Jingle Bells Ding Dong
Water Level 4-Note Chime Jingle Bells Dogs Barking Dong
No Sound* 8-Note Chime Dogs Barking Bell 4-Note Chime
Ding Knock Bell Buzzer 8-Note Chime
Ding Dong Jingle Bells Buzzer Knock
Dong Dogs Barking Jingle Bells
4-Note Chime Bell Dogs Barking
8-Note Chime Buzzer Bell
Knock Buzzer
Jingle Bells
Dogs Barking
Bells
Buzzer
*Zone light indicator still operates
CHART 2
Wireless Stopper ® Station Shield, Wireless Exit Stopper ® and Wireless Fire Extinguisher Theft
Stopper ® will need to use Advanced Programming message codes.