Anthro YES Cart for Tablets Assembly Instructions - Manual (Page 3)

Owner's Manual for Anthro Yes Cart for Tablets 3
• Feed the rest of the cord
into the IT area. [Image F]
• Slide devices into bays
so the power inlet is
convenient to the front of
the bay.
• Use the adhesive bay label
stickers to number each bay.
In the back IT area of the cart - READ QUICK GUIDE FIRST!
• Plug in each power adapter, then poke cable clips into the
holes in the pegboard divider – one cable clip per adapter
should do. You'll coil each cord and secure it into the cable
clip before plugging it into the adapter. [Image G]
• A great technique for coiling
cables is to wind them
around two fingers before
securing them in the cable
clips. [Image H] Be sure to
leave enough slack in your
cord so it can plug into the
adapter.
• Plug the cord into the
adapter. [Image I]
• For devices with large power
adapters, first bundle the
cord and adapter together
to save space, then plug
in the adapter. Finally, use
cable clips to secure the
bundle to the pegboard
divider.
• Turn the power switch to
the OFF position before
plugging the cart into the
wall. [Image J]
Loading Devices, Cable Management
In the front User area of the cart
• Check that the vertical spacing
of the shelves fits your devices.
To adjust shelf height, the
Anthro driver to loosen (not
remove) the 2 screws that
attach the left side of the
shelf. Lift the left side off the
screws and pull the shelf to
the left to free the tabs on
the right. Set aside the shelf.
Remove and reinstall the
screws and shelf at the desired
height. [Image A]
• Check that the horizontal
spacing of the bay dividers
fits your devices and cases. To
move the dividers and adjust
the bay width, press back on
the divider tab under the shelf
that connects the divider to the shelf until the divider pops
free. If your fingers don't fit, try a flat-head screwdriver. To
install the divider, angle the divider into a slot at the back of
the shelf, then tilt the divider into place at the front of the
shelf. [Image B] Number each
bay with the provided labels.
• To route the cords, route one
charging cord along the top of
each divider. Make sure that
the cord end that goes into
the device is at the front of the
bay and the power end goes
through the center panel and
into the IT area.
• Leave enough slack in front
(approximately 4.5”; use the
height of the divider as a
measuring stick) so users can
plug in the device without
straining the cord. [Image C]
• Weave the cord around the
short hook at the front of
the divider, then back and
forth through the three long
channels along the top of the
divider, including the center
channel that’s lower than the
others, and finally through the
short hook at the back of the
divider. [Image D and E]
C
D
E
F
G
H
I
J
A
B