Boltek EFM-INV3 - Manual (Page 9)

10/10/2012
(C) 2012 BOLTEK CORP EFM-INV_Instruction_1.2
COAT BOTH SIDES OF THE RUBBER WASHER WITH SILICONE GREASE
Connect Power, Ground and Fiber Optic connectors, then screw the Field Mill to its cover. Lower the
Shroud over the Field Mill. Lower the greased rubber washer onto Bulkhead Connector, and then the
Bulkhead Nut. Tighten the Bulkhead Nut until the Rubber Washer is visibly compressed.
PIPE WRENCH TIGHTENING NUT ONTO RUBBER WASHER
(NOTE: LEFT-HANDED COUNTER-CLOCKWISE THREAD ON NUT )