Boltek EFM-100 v.1 - Manual (Page 38)

C H A P T E R 3 – C O N F I G U R I N G T H E S O F T W A R E
32
SMS by Modem Configuration
Select the SMS by Modem checkbox to enable alerts to be sent through a SMS Modem.
Click on the settings icon to select the Com Port, baud rate and any special commands that may
be required to operate the modem.
Figure 27: SMS Modem Configuration
Please refer to your SMS Modem documentation for setup and access. Click Accept button to save
the current settings or Cancel to close Configure without saving the settings.
SMS by Gateway
Select the SMS by Gateway checkbox to enable alerts to be sent through a Click-A-Tell account. Click
on the settings icon to enter Username, Password, and API ID.
Figure 28: SMS Gateway Settings
Click Accept button to save the current settings or Cancel to close Configure without saving the settings.
To verify that the Alert settings are properly setup, click on the test button for that mode.
After all the alarm and alert settings have been setup, click the Accept button to save the current
configuration of the EFM-100 Options.