Brocade 6910 Ethernet Access Switch MIB Reference - Manual (Page 96)

84 Brocade 6910 Ethernet Access Switch MIB Reference
53-1002652-02
14
IronWare traps
NOTE
These traps apply to ports that have DHCP snooping is enabled.
CFM traps
Connectivity Fault Management (CFM) is an OAM protocol that includes proactive connectivity
monitoring using continuity check messages, fault verification through loop back messages, and
fault isolation by examining end-to-end connections between Provider Edge devices or between
Customer Edge devices. The following traps are generated if a suspect packet is detected.
NOTE
These traps apply to ports that have CFM enabled.
Traps for optics
Brocade supports for the following traps for optical transceivers.
Trap Name and Number Varbind Severity Description
snTrapSrcIpAddressViolation
brcdIp.0.84 snAgGblTrapMessage Minor The SNMP trap that is generated
when a rogue device spoofs sourceIP
address for denial of service attack.
Sample Trap Message:
Brocade Trap: Intruder
Source IP Address. <MAC
addr>; <IP addr>.
Trap Name and Number Varbind Severity Description
snTrapDot1agCfmDmThresholdTrap
brcdIp.0.199 dot1agCfmMepIdentifier Informational This trap is sent when an MEP
receives a 1DM/DMR with a
delay time that exceeds
specified threshold.
Trap Name and Number Varbind Severity Description
snTrapOpticalMonitoringWarning
brcdIp.0.1003 snAgGblTrapMessage Warning A warning occurred during optical
monitoring.
Sample Trap Message
Brocade Trap: Optical
Monitoring Warning.
<ifIndex>; <property>
{high | low}.
snTrapOpticalMonitoringAlarm
brcdIp.0.1004 snAgGblTrapMessage Alerts An alarm occurred during optical
monitoring due to a low
temperature in the device.
Sample Trap Message
Brocade Trap: Optical
Monitoring Alarm.
<ifIndex>; <property>
{high | low}.