Brocade Multi-Service IronWare Software Defined Networking (SDN) Configuration Guide (Supporting R05.6.00) - Manual (Page 42)

32 Multi-Service IronWare SDN Configuration Guide
53-1003034-02
openflow enable layer2|layer3 |layer23 hybrid-mode
1
openflow enable layer2|layer3 |layer23 hybrid-mode
Enables or disables the hybrid port mode on the port.
Syntax [no] openflow enable layer2|layer3 | layer23 hybrid-mode
Parameters slot/port Specifies the port that you want to enable or disable the hybrid port mode.
Command
Modes
User EXEC mode
Privileged EXEC mode
Global configuration mode
Usage
Guidelines
The show OpenFlow command displays the configuration for OpenFlow and gives the information
about hybrid mode port, protected VLAN ids and maximum number of protected VLANs allowed.
Brocade(config)# show openflow
Administrative Status: Enabled
SSL Status: Enabled
Controller Type: OFV 100
Number of Controllers: 1
Controller 1:
Connection Mode: passive, TCP,
Listening Address: 0.0.0.0
Connection Port: 6633
Connection Status: TCP_LISTENING
Match Capability:
L2 : Port, Source MAC, Destination MAC, Ether type, Vlan, Vlan PCP
L3 : Port, Vlan, Vlan PCP, Ethertype(IP,ARP,LLDP), Source IP, Destination IP, IP
Protocol, IP TOS, IP Src Port, IP Dst Port
L23: All
Normal Openflow Enabled Ports:
Openflow Hybrid Interfaces:
e1/1
Protected VLANs : None
Unprotected VLANs : 2, 3, 4, 5, 6, 7, 8, 9, 10, 11
......................................................
......................................................
3994, 3995, 3996, 3997, 3998, 3999, 4000, 4001, 4011,
e2/1
Protected VLANs : None
Unprotected VLANs : 4010,
Default action: drop
Maximum number of flows allowed: 65536
Active flow: 0
Maximum number of Protected Vlans allowed: 2048
Maximum number of Unprotected Vlans allowed: 4096
Total number of Unprotected Vlans: 4002