Brocade Fabric OS Encryption Administrator’s Guide Supporting HP Secure Key Manager (SKM) and HP Enterprise Secure Key Manager (ESKM) Environments (Supporting Fabric OS v7.2.0) - Manual (Page 291)

Fabric OS Encryption Administrator’s Guide (SKM/ESKM) 271
53-1002923-01
Management application encryption wizard troubleshooting
6
Errors related to adding a switch to a new group
Table 12 lists configuration task errors you might encounter while adding a switch to a new group,
and describes how to troubleshoot them.
TABLE 12 Error recovery instructions for adding a switch to a new group
Configuration task Error description Instructions
Initialize the switch Unable to initialize the switch due to an
error response from the switch. Diagnose the problem using standard switch CLI
commands.
The switch was not properly initialized
and was aborted because it is
unavailable. Rerun the Configure Switch Encryption wizard for the
switch.
Create encryption group on the
switch A failure occurred while attempting to
create a new encryption group on the
switch. 1 Click the Refresh button on the Configure Switch
Encryption dialog box to synchronize the data and
the database.
2 Rerun the Configure Switch Encryption wizard for
the switch.
Register one or more key vaults A failure occurred while attempting to
register one or more key vaults for a
group on the switch. 1 Remove the switch from the group using the Group
Members tab on the Encryption Group Properties
dialog box.
2 Rerun the Configure Switch Encryption wizard for
the switch.
Manual Option:
1
Launch the Encryption Group Properties dialog box
and click the General tab.
2 From the General dialog box, click Load from File to
install key vault certificates, and then click OK to
save the information on to the switch.
3 Follow the Key Vault instructions.
Enable the encryption engines A failure occurred while attempting to
enable encryption engines on the
switch. 1 Remove the switch from the group using the Group
Members tab on the Encryption Group Properties
dialog box.
2 Rerun the Configure Switch Encryption wizard for
the switch.
Manual Option:
1
Launch the Switch Encryption Properties dialog box.
2 Save the switch’s public key certificate to a file using
the Switch Encryption Properties dialog box.
3 Follow the Key Vault instructions for the key vault.