Brocade Fabric OS Encryption Administrator’s Guide Supporting HP Secure Key Manager (SKM) and HP Enterprise Secure Key Manager (ESKM) Environments (Supporting Fabric OS v7.2.0) - Manual (Page 92)

72 Fabric OS Encryption Administrator’s Guide (SKM/ESKM)
53-1002923-01
Adding target disk LUNs for encryption
2
• Encryption path table: Should be LUN/Path identified by the following:
- LUN Path Serial #
- Target Port
- Initiator Port
- Container Name
- Switch Name
- Fabric
- State
- Thin Provision LUN
- Encryption Mode
- Encrypt Existing Data
- Key ID
• Remove button: Remove s a selected entry from the table.
3. Click Add to launch the Add New Path wizard.
The Select Target Port dialog box displays. (Refer to Figure 46 .)
FIGURE 46 Select Target Port dialog box
The dialog box is used to select a target port when configuring multiple I/O paths to a disk LUN.
The dialog box contains the following information:
• Storage Array : The Storage Array selected from the LUN view prior to launching the Add
New Path wizard.
• Host: The host selected from the LUN view prior to launching the Add New Path wizard.
• Target Port table: Lists target ports using the following identifiers:
- Target Port
- Target Port Name
- Fabric
- Container Name