Brocade FICON Administrator’s Guide (Supporting Fabric OS v7.3.0) User Manual
Page 108
Switch configuration example and commands (Continued)
TABLE 13
Feature
Relevant Commands
Set port fencing. Setting port fencing parameters is much easier
with Brocade Network Advisor.
To clear alarms:
fwalarmsfilterset
0
To define alarms:
fwconfigure
Respond to menu driven prompts accordingly.
To enable the defined alarms:
fwalarmsfilterset
1
Parameters in the table below are only required when two-byte link addressing is used in the IOCP.
Normally, these parameters are not set when single-byte addressing is used.
Cascading (two-byte addressing) example and commands
TABLE 14
Feature
Parameter
Add members to the SCC Policy.
secPolicyCreate "SCC_POLICY", "wwn;wwn; ..."
Or, to add all switches already in the fabric, use an "*" for each
WWN:
secPolicyCreate "SCC_POLICY", "*"
Save the policy.
secpolicysave
Activate the policy.
secpolicyactivate
Enable the ACL Fabric-Wide Consistency Policy
and enforce a strict SCC policy.
fddcfg --fabwideset "SCC:S;"
Basic Switch Configuration
106
FICON Administrator's Guide
53-1003144-01