Brocade Mobility 7131N-FGR Access Point Installation Guide (Supporting software release 4.0.0.0-035GRN and later) - Manual (Page 35)

Resetting the access point’s password
3
Brocade Mobility 7131N-FGR Access Point Installation Guide 27
53-1001948-01
Enter the current password and a new admin password in fields provided, and
click Apply. Once the admin password has been updated, a warning message
displays stating the access point could be operating illegally unless set to
operate in the correct country. Proceed to
“Configuring basic device settings”
on page 27 to validate the country setting.
NOTE
Though the access point can have its basic settings defined using a number of
different screens, Brocade recommends using the Brocade Mobility 7131N-FGR
Access Point Quick Setup screen to define a minimum required configuration from
one location.
Resetting the access point’s password
The access point has a means of restoring its password to its default value. Doing
so also reverts the access point’s security, radio and power management
configuration to their default settings. Only an installation professional should reset
the access point’s password and promptly define a new restrictive password.
To contact Brocade Support in the event of a password reset requirement, go to
http://www.brocade.com/ .
CAUTION
Only a qualified installation professional should set or restore the
access point’s radio and power management configuration in the event
of a password reset.
Configuring basic device settings
Configure a set of minimum required device settings within the Quick Setup screen.
The values (LAN, WAN etc.) can often be defined in other locations within the menu
tree. When you change the settings in the Quick Setup screen, the values also
change within the screen where these parameters also exist. Additionally, if the
values are updated in these other screens, the values initially set within the Quick
Setup screen will be updated.
AP7131N_InstallationGuide.book Page 27 Tuesday, August 24, 2010 5:09 AM