Brocade Virtual ADX Security Guide (Supporting ADX v03.1.00) - Manual (Page 98)

86 Brocade Virtual ADX Security Guide
53-1003250-01
DDoS protection
5
• “Configuring a rule for ip-option attack types” on page 89
• “Configuring a rule for icmp-type options” on page 90
• “Configuring a rule for IPv6 ICMP types” on page 92
• “Configuring a rule for IPv6 ext header types” on page 92
• “Binding the filter to an interface” on page 93
Configuring a security filter
Configuring a a security filter requires you to define it by name and configure rules within it as
shown in the following.
Virtual ADX(config)#security filter filter1
Virtual ADX(config-sec-filter1)#rule xmas-tree drop
Syntax: security filter filter-name
The filter-name variable specifies the filter being defined that will then be bound to a port.
The rule command defines the attack method that is being filtered for. For each rule, you can
configure whatever action needs to be taken if an attack occurs. The Brocade Virtual ADX can log
the attack and drop the attacking packet. Rules that can be used are described in
Table 9 through
Table 14 of this chapter.
Example
Virtual ADX(config)#security filter filter1
Virtual ADX(config-sec-filter1)#rule xmas-tree log
Virtual ADX(config-sec-filter1)#rule address-sweep 1 3 drop log
NOTE
There is no set limit on the number of filters that can be configured on a Brocade Virtual ADX but a
maximum of 10 rules can be bound to a single interface. The global limit depends upon the available
memory.
Configuring a Generic Rule
Apart from regular rules, such as those configured above, there is also a generic rule. A generic rule
needs to be defined before it can be bound to a filter. In the following example, a rule (gen1) is
configured to match a TCP packet with a source IP greater than 10.10.1.101, a TCP dest-port
greater than 20 and a string "400" at the 3rd byte offset from l4 (Layer 4) data.
Virtual ADX(config)#security generic gen1
Virtual ADX(config-sec-gen-gen1)#ip-source gteq ip 10.10.1.101
Virtual ADX(config-sec-gen-gen1)#tcp-dest gt val 20
Virtual ADX(config-sec-gen-gen1)#l4-data 3 eq str "400"
Syntax: [no] security generic generic-rule-name
The generic-rule-name variable specifies the generic rule defined that will then be bound to a filter.
The following conditions can be applied to any of the fields in the mac-header, ip-header, Layer 4
header (TCP/UDP), and Layer 4 data offset to create generic rules:
• eq equals