Burcam 700722 BRASS GEAR PUMP 1 SUCTION AND DISCHARGE - Manual (Page 3)

FOR INFORMATION TEL: 514.337.4415 FAX: 514.337.4029
3
STEP 1
STEP 2
INSTALLATION STEPS
This pump may be mounted direct to tractor PTO shaft with solid coupling or flexible
coupling, or belt driven for operation with gasoline engines or electric motors. Pump
may also be driven direct to an electric motor using solid coupling, providing the
motor and the pump shaft line up properly and secured to a common base. When
belt driven, shafts must be parrallel and the pûlleys in line with one another.
Be sure to avoid pressing coupling or pulley against pump body to avoid wear.
Avoid excessive rough handling and pounding on pum housing or drive shaft when
mounting or removing pulleys or couplings, other wise serious damage to the pump
will result.
Caution regarding abrasives ;
The company, (burke water systems manufacturing inc.) cannot extend any guarran-
tee whatsoever as to the life expectancy of each pump because of the varying fac-
tors, or combinations of factors, such as types of liquid pumped under varying oper-
ating conditions. abrasive spraying material, sand, dirt, grit, silt, etc., will shorten the
life expectancy. user should take every precaution to avoid such applications as will
subject the pump to heavy abrasive wear. An efficent filter or strainer should be fitted
to the end of the suction line, to ythe pump’s inlet. Wrapping a piece of flannelette
around the screen on the foot valve or4 strainer sa as to reduce abrasive material to
a minimum, will make an efficient filter.
WARRANTY 30 DAYS FROM PURCHASE ON DEFECTS IN MATERIAL
OR WORKMANSHIP.
TYPICAL INSTALLATION