Burcam 750896 SAND FILTER 1 1/4 INLET AND OUTLET - Manual (Page 2)

FOR INFORMATION TEL: 514.337.4415 FAX: 514.337.4029
OPTION 1
OPTION 2
OPTION 3
IMPORTANT NOTICE
HERE ARE SOME THINGS YOU SHOULD KNOW ABOUT YOUR NEW
VISUAL LIQUID STRAINER
The VLS will stop sand and grit over 170 microns from getting in your critical valves and
pump parts, etc.
If the clear sleeve of the VLS gets dirty, and you can’t see the screen, take the VLS
apart and clean well. You want to be able to see the screen.
If you find that you have to empty the VLS quite often, you may want to put 2 units in
parallel.
If you put in 2 units with shutoff valves, you can clean one while the other keeps work-
ing.
If you accidentally damage the screen beyond repair, you can operate the VLS without a
screen while waiting for a replacement.
1
2
3 5 7
8
4 6 PARTS LIST
1 Bar-C-W stud
2 Nylon washer
3 Body
4 Plastic sleeve
5 Screen
6 “O” rings (2)
7 T-nut
8 Cap
INSTALLATION STEPS
Your VLS comes with 1 ¼’ iron pipe thread “in and out”. Some of the ways it can be
adapted for other sizes are shown below.
1/2 inch copper pipe parts needed.
1- 1/2” union copper to copper
2- 1/2” male adapter copper MIP
3- Galvanized bushing 1/2” X 1 ¼”.
1 inch plastic pipe. NOTE Support is needed for VLS
when plastic pipe used in and out.
1- Male adapter 1”
2- Galvanized bushing 1 X 1¼”.
1 inch plastic pipe with shutoff valve.
1- Male adapter 1”
2- Globe valve 1”
3- 1 inch IPS galvanized nipple. lenght as needed.
4- Bushing 1 X 1¼”.
1
1
1
2 3
2
3
4 2