Burcam 750896 SAND FILTER 1 1/4 INLET AND OUTLET - Manual (Page 3)

FOR INFORMATION TEL: 514.337.4415 FAX: 514.337.4029
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
Specifications
Max. Press.: 100 PSI
Max. Temp.: 130 0 F (55 0 C)
Max. Vaccum: 30 In
Screen Mesh: 60
Screen Material: Brass
Thread Size: 1¼ In IPS
Body Material: Cast iron
Service parts kits
Description:
O-ring set
Screen
Plastic sleeve
c-w O-rings
NOTE:
If VLS leaks around the
sleeve joint, disasemble
and check O-rings for
damage or dirts as in
step 3.
CLEANING INSTRUCTIONS
DISASSEMBLY
Remove T-nut completely.
If the VLS has not been cleaned for some time, it may be necessary
to use a wrench.
Twist the bottom cap back and forth to loosen.
Remove bottom cap, sleeve and screen - straight down, - if possible,
to avoid damage to screen.
Then clean thoroughly.
Make sure O-rings and gooves are cleaned and that O-rings
are undamaged.
REASSEMBLY
Carefully adjust screen in bottom cap. Check that the rubber seal on
the free end is properly in place.
Put the clear sleeve in place on the bottom cap.
Rotate a little to seat on O-ring gasket.
Carefully replace screen, sleeve and bottom cap on main body.
CAUTION: Be careful not to damage screen against the stud.
Make sure the screen is properly seated in the upper body.
DO NOT FORCE.
Hold cap, sleeve and screen in place with one hand.
With the other, thread the T-nut on for 2 or 3 threads.
Make sure the screen is properly seated in the cap.
Then rotate the cap back forth until is feels “solid”.
Gently snug up the T-nut.
Rotate the cap back and forth about ¼ turn to be sure all is seated.
Tighten T-nut about ¼ turn.
repeat until cap will no longer turn.
Tighten T-nut.
1
2
3
4
5
6
7
8
HEAD LOSS FEET
OF W
A
TER
FLOW OF WATER (US GPH)
2
5
4
6
8
10
10 15 20 30