Earthway Outlet 2150SU - Manual (Page 2)

4. Install gear box by inserting the pinion shaft into hole in
center of hoppers bottom. The word “FRONT” on the gearbox
must point to Front of the hopper. Follow label instructions on
hopper.
5. Install axle bearings to both lower handles. NOTE: Notch on bearings
and lower handles. Bearings must go through flat side of lower handle.
3. Install impeller onto pinion shaft. Insert
⅛”
x 1-1/4” cotter pin
through impeller then through pinion shaft. Use hole closest to the
gear box. Spread cotter pin to prevent from falling out.
6. A - Install lower handles onto axle to both sides as shown. Insert 2 ¼ ”
bolt through second hole in lower handle and through first hole in frame
install locknut. DO NOT TIGHTEN.
B - Now insert 1
½ ” bolt through first hole in lower handle. Then through
frame brace. NOTE: Dimples on frame brace must be facing toward gear
box as shown. Next into threaded connector in cross brace. DO NOT
TIGHTEN.
C - Next insert 1
½ ” bolt through other end of frame brace and through
second hole in frame install locknut.
NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST STEP. DO NOT OVER TIGHTEN.
PAGE 2