Earthway Outlet 2150SU - Manual (Page 3)

7. Slide axle bushing over axle and into axle
bearing to both sides as shown.
8. Install drive wheel to axle using pin hole nearest to lower handles as shown. Insert 2” cot-
ter pin through wheel and through axle. Bend with pliers to prevent pin from falling out.
10. NOTE: BEFORE INSTALLING GAUGE AND UPPER
HANDLES TO HANDLE SHAFT, UPPER HANDLES FEATURE
THREE POSITIONS FOR OPERATOR’S COMFORT.
If operator
chooses middle or upper positions, use handle spacer in hole nearest
to handle grips. Insert 1¾” bolt through upper handle
, then through
handle spacer through other upper handle. DO NOT TIGHTEN LOCK-
NUT YET. TIGHTEN THIS NUT LAST. Install gauge & lever using
(2) 1¾” bolts. Be sure gauge is on left hand side. Tighten locknuts
to gauge first. TIGHTEN NOW.
11. Insert pivot rod into shut off plate as shown. Turn to lock in
place.
12. Insert other end of pivot rod into pivot and bracket assembly as
shown. Turn to lock in place.
PAGE 3
9. Install coast wheel to axle using outside pin hole. As shown, insert 1” cotter pin
through axle (not thru the wheel). Bend with pliers to prevent pin from falling out.
TURN SPREADER UPRIGHT ON TO WHEEL.
Axle bushing
Axle bearing
Slide Axle
bushing