Elitegroup PMI8M (V2.0) - Manual (Page 39)

33
Using BIOS
USB Controller (Enabled)
Enable this item if you plan to use the Universal Serial Bus ports on this motherboard.
USB 2.0 Controller (Enabled)
Enable this item if want to use the USB 2.0.
USB Keyboard Support (Disabled)
Enable this item if you plan to use a keyboard connected through the USB port in a
legacy operating system (such as DOS) that does not support Plug and Play.
UltraDMA technology, which provides faster access to IDE devices. If you install a
device that supports UltraDMA, change the appropriate item on this list to Auto.
You may have to install the UltraDMA driver supplied with this motherboard in order
to use an UltraDMA device.
IDE DMA transfer access (Enabled)
This item allows you to enable the transfer access of the IDE DMA.
Delay For HDD (Secs) (0)
Users may set a delay from 1 to 15 seconds in the cold boot process. Some hard disk
drives need extra time to spin up in order to identify correctly. If the system does not
start after the memory test, try to add times in this field.
IDE HDD Block Mode (Enabled)
Enable this field if your IDE hard drive supports block mode. Block mode enables
BIOS to automatically detect the optimal number of block read and writes per sector
that the drive can support and improves the speed of access to IDE devices.
IDE Primary/Secondary Master/Slave UDMA (Auto)
Each IDE channel supports a master device and a slave device. This motherboard
supports
Onboard Device (Press Enter) f
Phoenix-AwardBIOS CMOS Setup Utility
Onboard Device
Item Help
Menu Level
ff
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
mnlk
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized
USB Controller [Enabled]
USB 2.0 Controller [Enabled]
USB Keyboard Support [Disabled]
USB Mouse Support [Disabled]
AC97 Audio [Auto]
Onboard LAN 1 Device [Enabled]
Onboard LAN Boot ROM [Disabled]
*Onboard LAN 2 Device [Enabled]
Init Display First [PCI Slot]
Press <Esc> to return to the Integrated Peripherals page.