Elitegroup PMI8M (V2.0) - Manual (Page 40)

34
Using BIOS
Onboard LAN 1 Device (Enabled)
This option allows you to enable or disable the onboard LAN function.
Onboard LAN Boot ROM (Disabled)
Use this item to enable and disable the booting from the onboard LAN or a network
add-in card with a remote boot ROM installed.
Onboard LAN 2 Device (Enabled)(optional)
This option allows you to enable or disable the onboard LAN function.
Init Display First (PCI Slot)
Use this item to specify whether your graphics adapter is installed in one of the PCI
slots or is integrated on the motherboard.
Press <Esc> to return to the Integrated Peripherals page.
SuperIO Device (Press Enter)
f
POWER ON Functio n (BUTTON ONLY)
This feature allows you to set the method by which your system can be turned on.
Hot Key Power On (Ctrl-F1)
When the POWER ON Function is set to Hot Key, use this item to set the hot key
combination that turns on the system.
Onboard FDC Controller (Enabled)
This option enables the onboard floppy disk drive controller.
Onboard Serial Port1~3 (3F8/IRQ4, 2F8/IRQ3)
These options are used to assign the I/O address and interrupt request (IRQ) for
onboard serial port1~2.
Onboard Serial Port3 (3E8)
These options are used to assign the I/O address and interrupt request (IRQ) for
onboard serial port3.
Serial Port 3 Use IRQ (IRQ10)
This item is used to select an IRQ for the onboard serial port 3.
Phoenix-AwardBIOS CMOS Setup Utility
SuperIO Device
Item Help
Menu Level
ff
POWER ON Function [BUTTON ONLY]
Hot Key Power ON [Ctrl-F1]
Onboard FDC Controller [Enabled]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Serial Port 2 [2F8/IRQ3]
Onboard Serial Port 3 [3E8]
Serial Port 3 Use IRQ [IRQ10]
Onboard Serial Port 4 [2E8]
Serial Port 4 Use IRQ [IRQ11]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [ECP]
EPP Mode Select [EPP1.7]
ECP Mode Use DMA [3]
Power On After Power Fail [Off]
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
mnlk
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized