Elitegroup NM70-I2 (V1.0) - Manual (Page 37)

Chapter 3
NM70-I2 USER MANUAL
33
Power Management Setup
This page sets up some parameters for system power management operation.
Resume By PME (Disabled)
This item specify whether the system will be awakened from power saving modes
when activity or input signal of the specified hardware peripheral or components is
detected.
Resume By USB(S3) (Disabled)
This item allows you to enable/disable the USB device wakeup function from S3
mode.
EUP Function (Enabled)
This item allows user to enable or disable EUP support.
Press <Esc> to return to the Advanced Menu page.
Power Management Setup
Resume By RING [Disabled]
Resume By PME [Disabled]
Resume By USB(S3) [Disabled]
Resume By PS2 KB(S3) [Disabled]
Resume By PS2 MS(S3) [Disabled]
EUP Function [Enabled]
Power LED Type [Dual Color LED]
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Main Advanced Chipset Tweak Boot Security Exit
Version 2. 15.1229. Copyright (C) 2012 American Megatrends, Inc.
About Resume by Ring
F1:General Help
+/- : Change Opt.
Enter : Select


:Select Screen
:Select Item
F2:Previous Values
F3:Optimized Defaults
F4:Save & Exit
ESC:Exit
Resume By RING (Disabled)
The system can be turned off with a software command. If you enable this item, the
system can automatically resume if there is an incoming call on the Modem. You
must use an ATX power supply in order to use this feature.
Power LED Type (Dual Color LED)
This item shows the type of the power LED.

Resume By PS2 MS (S3) (Disabled)
This item enables or disables you to allow mouse activity to awaken the system
from power saving mode.
Resume By PS2 KB (S3) (Disabled)
This item enables or disables you to allow keyboard activity to awaken the system
from power saving mode.