Hired-Hand Light Traps: Light Trap Fan Unassembled - Manual (Page 4)

HIRED-HAND, INC. 1733 Co Rd Bremen, AL 35033 Phone 256-287-1000 Fax 256-287-2000
Manual Part No. 4801-2984
LIGHT TRAP EXTRUSIONS ASSEMBLY
AND INSTALLATION
1. Assemble the Light Trap Extrusions according to the
separate instructions which are included with the Light Trap
Extrusions.
2. Insert the assembled Light Trap Extrusions as shown in
Figure 10. Note the orientation of the of the Light Trap
Extrusions with respect to te Bottom and Sides of the
unit. Some force may be needed to push the Light Trap
into the assembly.
3. Slide the Light Trap into the assembly until the stops are
encountered.
FAN INSTALLATION
1. Cut rough opening in wall.
a) 48” fans—54 3/4” horizontal x 55 3/4” vertical
b) 36” fans---42 3/4” horizontal x 43 3/4” vertical
c) 24” fans---30 3/4” horizontal x 31 3/4” vertical
2. Place fan through opening, blade end first.
3. Slide fan through opening until the flange is against the wall
(See Figure 11).
4. Secure fan to wall with wood screws.
5. Install shutter. Shutter can be either inlet or exhaust.
6. Installation complete.
OTHER PRODUCTS
Check out Hired-Hand’s New 7 x 44 In.
And 54 x 54 In. Light Trap Inlets
Top
Side
Shutter
Inlet
Exhaust
This Flange should
be flush with wall
Figure 9
Figure 10
Figure 11
Bend Retainer
Clips Firmly