Vent duct installation (optional) – Hired-Hand Baffles, Vents, & Inlets: Vent Kit for Generation Structures User Manual
Page 7
HIRED-HAND MFG., INC.
• 1733 Co Rd 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 256-287-2000
Manual Part No. 4801-5370 rev 6-04 Page
7 of 8
VENT DUCT INSTALLATION
(Optional)
NOTE: The vent duct is sold separately and not
included with this kit. The vent duct is
necessary only if outside-air ventilation is
required instead of attic-air ventilation.
1. Assemble the vent duct as described in Section I,
Vent Duct Assembly.
2. Insert the vent duct between the column and
intermediate post and place the duct so that the vent
duct notches fit on the corner tin ridges as shown in
Figure 17.
3. Screw the vent duct side flanges to the columns with
#8 x ½” pan-head screws. Refer to Figure 18.
4. Cut the bird wire to the appropriate size to fit over
the top, bottom, and side duct flanges. Secure the
bird wire to the column with two #8 x ½” pan-head
screws. Pull the wire tight and attach opposite side
with two #8 x ½” pan-head screws.
VENT DUCT PLACEMENT
Tin Ridge
FIGURE 17
VENT DUCT
&
BIRD WIRE
FIGURE 18
#8 x ½” Pan-Head Screws
NOTE:
Wire must be stretched tight.