Hired-Hand Mega Flow SlantWall Fans: METAL CONE Installation Rev 2-09 - Manual (Page 2)

HIRED-HAND MFG., INC. • 1733 County Road 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 256-287-2000
Manual Part No. 4801-5180 Rev 2-09 Page 2 of 2
Pilot hole
at top
outside of
cone
Mounting Brackets
Top and Bottom bolts are
inserted from inside the
cone.
4. To complete the last flange
connection, roll the cone panels
so the small end is on the floor.
See Figure 2. IMPORTANT!
The four pilot holes should be at
the top end on the outside of the
cone.
5. Install the cone Mounting
Brackets to the fan housing
using two 5/16”-18x5/8” carriage
bolts in each mounting bracket.
6. Mount cone to fan. Bend the
mounting brackets back slightly
to help clear the area of the
cone edges. Hang the centered
slot in the small end of the cone
over the Pim screw mounted on
the Fan housing. See Figure 3.
Screw can be fastened with
¼”x20 lock nut, if necessary (not
included).
7. Align the cone over the
remainder of the fan housing.
Using four 1/4”-20x3/4” Truss
Head Phillips bolts and 1/4-20
lock nuts, insert the bolts from
the inside of the cone. See
Figure 4.
Cone attaches over
the top Pim screw
Figure 3: Install Cone Mounting Brackets
Figure 2: Assembled Cone
Figure 4: Mount Cone onto Fan