Figure 2: form support brackets, Figure 4: install bracket to cone, Figure 3: support bracket mounting holes – Hired-Hand Mega Flow SlantWall Fans: Fan & Cone Installation User Manual
Page 5
HIRED-HAND MFG., INC.
• 1733 County Road 68 • Bremen, Alabama 35033 • PHONE 256-287-1000 • FAX 256-287-2000
Manual Part No. 4801-5323 Rev 6-08 Page 5 of 10
48/52" Cone Fan Bracket (0404-5640)
48
″ Fan
52
″ Fan
Holes to Mount Bracket
4.
Four corner support brackets are supplied as flat
perforated metal sheets with flanges. Bend each
sheet along perforations as shown in Figure 2 to
form support brackets.
5.
Figure 3 shows the three different corner support
brackets and the correct attachment holes for
mounting to the specific cone size.
6.
Install three corner brackets to joints of panel
assembly as shown in Figure 4. Attach each
corner bracket to two holes in the cone nearest the
small cone opening with 1/4" bolts and nuts. To
install bolt, insert bolt through hole of bracket, then
through hole of flange, and into hole of tab as
shown in Figure 4. NOTE: Start nuts onto bolts.
Leave nuts and bolts loose until cone is installed in
unit.
Flat sheet
Bend along
perforations
Support ready
for installation
Figure 2: Form Support Brackets
Guard Mounting Hole
Corner Support
Bracket
Tab fits to side of
flange opposite
bracket
Flange
Figure 4: Install Bracket to Cone
Figure 3: Support Bracket
Mounting Holes
36" Cone Fan Bracket (0404-4834)
Holes to Mount Bracket