Hired-Hand Mega Flow SlantWall Fans: Fan & Cone Installation - Manual (Page 7)

HIRED-HAND MFG., INC. • 1733 County Road 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 256-287-2000
Manual Part No. 4801-5180 Rev 6-08 Page 7 of 10
Arrange panels for assembly
with pilot hole on each panel
facing upward.
Slot for mounting top of
cone to fan housing Joints
Install #14 x 1/2" sm
screw
Install #14 x 1/2" sm
screw
Pilot hole faces upward
Pull flanges
together to
align
mounting
holes
Mounting
Hole for
Wire Guard
Packing List For One (1) 54
″ Unit
Tools Required
Four (4) Cone Sections Four (4) Corner Brackets 7/16 in. (11 mm) Wrench Ratchet
One (1) Wire Guard
Eight (8) 5/16"-18 x 5/8 Carriage
Bolts
7/16 in. (11 mm) Socket Marker or Scribe
Five (5) 1/4"-20 Lock Nuts Ten (10) #14 x 1/2" SIM Screws Cordless drill and bit (For Installing TEK screws)
Four (4) ¼"-20 x 3/4" Bolts One (1) Installation Manual
1. Arrange panels contacting as shown in Figure 1. NOTE: The pilot hole pointing upward. Refer to Figure 7
Inset B.
2. For each panel, slide panels together. See Figure 7 Inset A.
3. Align holes of flanges. See Figure 7 Inset A. Install sheet metal screws as shown in Insets B and C.
Mounting Holes for
Damper Ring
Figure 7
Inset A
Figure 7
Inset C
Figure 7:
Inset B
C O N E I N S T A L L A T I O N
5 4
″