Kushlan Products KPC160W - Manual (Page 4)

4
The machine is best suited to the compaction of bituminous and granular materials e.g. granular soils such as silt and
clay are best compacted using the impact force produced by a vibrating rammer.
Where possible the site should be graded and leveled before commencing compaction.
For more information of starting and correct operating procedures o the motor, refer to the motor operation manual
supplied with the unit.
Increase the motor sped to the maximum setting using the hand throttle lever, before commencing compacting.
The machine should be controlled by grasping the handle with supplied with the unit.
Increase the motor sped to the maximum setting using the hand throttle lever, before commencing compacting.
The machine should be controlled by grasping the handle with both hands and applying restraint to control the for-
ward motion.
Steer the machine by moving the handle sideways to the right or left;
ALWAYS maintain good footing so that you do not slip and loose control when starting or operating the machine;
Inspection the water hose and its connections to ensure that they do not leak.
CARE AND PREVENTIVE MAINTENANCE
Check the oil level in the motor crankcase daily.
Check the vibrator oil level weekly.
Inspect the rubber anti vibration mounts for wear or deterioration.
Inspection the water hose and its connections to ensure that they do not leak.
Clean the underside of the plate regularly to prevent a build up of material.
Use unleaded grade petrol and ensure that the fuel is free from contamination.
The vibratory motion provides a self propelling action.
Position the handle at the opposite end of the machine to the vibrator.
Start the motor using the recoil starter.(If the motor is fitted with an on/off switch this must first be turned to ON
before starting.)
Correct moisture content in soil is vital to proper compaction.
Water acts as a lubricant to help slide soil particles together.
Too little moisture means inadequate compaction; too much moisture leaves water-filled voids that weaken the soil's
load bearing ability.
Compaction of dry materials will be facilitated by moistening with a water hose fitted with a sprinkler.
Excessive watering or water content will cause the machine to stall.
The optional water tank kit is recommended when the machine is used on bituminous surfaces as the water fulm prevents
A build up of material on the underside of the plate.
CAUTION
Inspection and other services should always be carried out on hard and level ground with the engine shut down.
Inspection and maintenance Service Tables
To make sure your plate compactor is always in good working condition before using. carry out the maintenance in-
spection in accordance with Tables 1 through 3.
TABLE 1. MACHINE INSPECTION
ITEM Hours of Operation
(Starting Check) Every8 hours ( every day)
Loosened of lost screws Every8 hours ( every day)
Damage of any part Every8 hours ( every day)
Function of controlling system part Every8 hours ( every day)
Vibrator oil check Every 100 hours
Vibrator oil replacement Every 100 hours
V-belt (Clutch) Check Every 100 hours