Lincoln Electric IM700 Commander 300 - Manual (Page 29)

K1604-1 OIL DRAIN KIT - Includes ball valve, hose
and clamp.
K1690-1 (1 Duplex) GFCI Kit - Includes one UL
approved 115V ground fault circuit interrupter duplex
type receptacle with cover and installation instruc-
tions.Replaces the factory installed 115V duplex recep-
tacle.The receptacle of the GFCI duplex is rated at 20
amps,the maximum total current from the GFCI duplex
is limited to 20 amps. Two kits are required.
K1768-1 Dual Output Meters and Gauges - Dual out-
put meters provide preset ability of voltage for wire
welding and current for stick welding. Measures both
current and voltage when welding. Gauges includes:
battery ammeter, engine temperature, and engine oil
pressure. Fuel gauge is not available in kit form.
K1816-1 Full KVA Adapter Kit - Plugs into
the120/240v NEMA 14-50R receptacle on case front
(which accepts 4-prong plugs) and converts it to a
NEMA 6-50R receptacle, (which accepts 3-prong
plugs.
Pipe Thawing with an arc welder can cause fire,
explosion, damage to electric wiring or to the arc
welder if done improperly. The use of an arc welder
for pipe thawing is not approved by the CSA, nor is
it recommended or supported by Lincoln Electric.
------------------------------------------------------------------------
C-1 ACCESSORIES C-1
OPTIONAL FIELD INSTALLED
ACCESSORIES
K802N POWER PLUG KIT - Provides four 120V
plugs rated at 20 amps each and one dual voltage, full
KVA plug rated at 120/240V, 50 amps. 120V plug may
not be compatible with NEMA common household
receptacles.
K802R POWER PLUG KIT - Provides four 120V plugs
rated 15amps each and one dual voltage, full KVA plug
rated at 120/240V, 50 amps. 120V plug is compatible
with NEMA common household receptacles.
K857 25 ft. (7.5 m) or K857-1 100 ft. (30.4 m)
REMOTE CONTROL - Portable control provides same
dial range as the output control on the welder from a
location up to the specified length from the welder. Has
convenient plug for easy connection to the welder. The
Commander 300 is equipped with a 6 pin connector for
connecting the remote control.
K704 ACCESSORY SET - Includes 35 feet (10 m) of
electrode cable and 30 feet (9 m) of work cable, head-
shield, work clamp and electrode holder. Cable is rated
at 500 amps, 60% duty cycle.
(K953-1) TRAILER - Two-wheeled trailer with optional
fender and light package. For highway use, consult
applicable federal, state, and local laws regarding pos-
sible additional requirements. There is a choice of 2
hitches, a fender & a light package. Order: K953-1
Trailer
K958-1 Ball Hitch
K958-2 Lunette Eye Hitch
K959-1 Fender & Light Kit
K965-1 Cable Rack
(K767-2) TRAILER - Four-wheeled steerable yard
trailer for in plant and yard towing:
K887-1 ETHER START KIT - Provides maximum cold
weather starting assistance for frequent starting below
10 oF (-12.2 oC). Required Ether tank is not provided
with kit.
K1898-1 SPARK ARRESTOR KIT - Easily mounts to
standard muffler. Approved by U.S.D.A. Forest
Service.
COMMANDER 300
WARNING