ASA Electronics AVT-1928 - Manual (Page 13)

Changing Channels
You can change channels in three ways:
Changing the Volume
Changing the TV’s Channel Memory
Your TV’s memory determines the channels that are available using the
CH buttons. You can add channels to this memory or remove them
from memory. If a channel is removed from memory, you can tune to it
with the number buttons, but you cannot tune to it with the CH
buttons.
Chapter 3: Operating Your TV-11
1. The CH buttons take you through all
memorized channels, one by one. The Ch
buttons will not access channels that have not been
programmed into the TV’s memory. For more
information about programming channels into
memory, see the section “Programming your TV’s
Channel Memory,” above.
2. The number buttons (0-9) will take you to any
channel, even if it has not been memorized. To
change to a channel, enter it’s number; the TV will
tune to the new channel when you enter the second
digit of the channel.
3. The PREV.CH button will take you instantly to the
last channel you were watching.
1. To change the volume of the TV set, use the VOL
buttons on the remote or on the front panel.
2. To quickly turn off the sound, press the MUTE button
on the remote. The volume bar will appear on the
screen, colored red. To return the volume to it’s
previous level, press MUTE again.
1. Use the number buttons to tune to the channel
2. Press the ADD/ERA button on the remote control.
The channel will turn from magenta to green to
show it has been added.