LT Security LTD2284HMK - Manual (Page 23)

to enter into system maintain setup interface.
AUTO RESET: When it is on, you can setup the time for device to restart.
SYSTEM UPDATE: Copy the update file to the root directory of a thumb driver, then insert it
into USB 1.0. Press [Enter] to upgrade the firmware and it will display the process of the
system upgrade as follow:
DEFAULT SETTINGS: Restore all the settings to factory settings.
2.2.2.5.6 PTZ SETUP
Move the cursor to【PTZ SETUP】（Icon highlighted when selected），press【Enter】to access
setting interface. You can setup the parameters for each channel separately.
CHANNEL: The channel with PTZ connected.
PROTOCOL: select the protocol of different PTZ: two protocols for your selection. Default is
Pelco-D.
BAUD RATE: select the different baud rate for your PTZ: 1200, 2400, 4800, and 9600.
DATA BIT: Four options: 5,6,7,8 for your selection. Default setting is 8.
STOP BIT: Two options: 1 and 2 for you selection. Default setting is 1.
23