Appendix, Hardwarereset, Hardware – LT Security IP85PW User Manual
Page 54: Hardware reset, Reset, 5. appendix appendix appendix appendix
- 54 -
5.
5.
5.
5. Appendix
Appendix
Appendix
Appendix
5.
5.
5.
5.1.
1.
1.
1. Hardware
Hardware
Hardware
Hardware Reset
Reset
Reset
Reset
After updating the IP device, or when there are some problems that you can’t
solve via reboot, for example, you can’t get the IP address via the search tool,
please try to reset the IP device. After this reset, all the parameters will be back to
the factory default, the IP address will be back to default: 192.168.1.199. Then
please set the IP address again according to the chapter:
Please following the below to finish the reset:
�
Step 1 Cut off the power of IP device, all the indicate lamps are off.
�
Step 2 Press the “RST” button with a pin, don’t release.
�
Step 3 Connect the power to the IP Device, the “STATE” indicate lamp will
flicker. Hold on another 30 seconds.
�
Step 4 Release the pin. Now, you can access the IP device now. Reset
successfully,
NOTE: If the reset is successful, the IP address will turn back to the default: